RepRap Prusa i3 - Marlin G-Code Commands; Reference List of G-Code Commands

Document Version 1.1.16Document Version 1.1.16
/ 37
ANNEX
Ccommandes GCODE
G1 : linear motion (ex : G1 X100 Y100 F3000)
G28 : back to home (ex : G28 X Y)
M500 : save l’EEPROM
M851 : dene «Z Probe Height» value (ex : M851 Z-0.49)
M999 : restart printer
G29 : inductive probe at actual place
G30 : inductive probe at plate’s corners
M110 : Set the current Line Number
M17 : Enable/Power all stepper motors
M410 : Quickstop. Abort all planned moves, stopping the printer.
M24 : Start/resume SD print
M104 S205 : heating the extruder at 205°C and doesn’t wait
M109 S205 : heating the extruder at 205°C and wait until the temperature is reached
M140 S55 : heating bed at 55°C and wait until the temperature is reached
Note : all Marlin’s GCODE at http://www.marlinrmware.org/index.php/G-Code_in_Marlin