ResMed AirSense 10 Series User Manual

8
Caring for your device
It is important that you regularly clean your AirSense 10 device to make sure you receive optimal
therapy. The following sections will help you with disassembling, cleaning, checking and
reassembling your device.
WARNING
Regularly clean your tubing assembly, water tub and mask to receive optimal therapy and to
prevent the growth of germs that can adversely affect your health.
Disassembling
1. Hold the water tub at the top and bottom, press it gently and pull it away from the device.
2. Open the water tub and discard any remaining water.
3. Hold the cuff of the air tubing and gently pull it away from the device.
4. Hold both the cuff of the air tubing and the swivel of the mask, then gently pull apart.
Cleaning
You should clean the device weekly as described. Refer to the mask user guide for detailed
instructions on cleaning your mask.
1. Wash the water tub and air tubing in warm water using only mild detergent.
Do not wash in a dishwasher or washing machine.
2. Rinse the water tub and air tubing thoroughly and allow to dry out of direct sunlight and/or heat.
3. Wipe the exterior of the device with a dry cloth.

ResMed AirSense 10 Series Specifications

General

Pressure Range	4-20 cm H2O
Humidifier	Integrated HumidAir Humidifier
Therapy Modes	CPAP, AutoSet, AutoSet for Her
Altitude Adjustment	Automatic
Device Type	CPAP Machine
Dimensions	116 mm x 255 mm x 150 mm
Weight	1248 grams
Data Storage	SD card
Ramp	Yes
EPR (Expiratory Pressure Relief)	Yes
Heated Tubing	Optional ClimateLineAir heated tubing
AC Voltage	100–240V
Display	Color LCD
Noise Level	26 dBA
Data Recording	Usage, Leak, AHI, Events