10
HOW TO ATTACH A HUMIDIFIER
ATTACH A HUMIDAIRE 3
i
HUMIDIFIER
Please refer to the illustration in section E of the illustration sheet, and your HumidAire 3i
manual.
The
HUMIDAIRE 3
i
attaches to the front of the S8 COMPACT to provide heated
humidification. No other accessories are required for its use.
Notes:
a. Make sure the water chamber of the HumidAire 3i is empty before you attach or
detach the humidifier.
b. Remove the connector plug on the S8 Compact (see section
A of the illustrations
sheet) before you attach the HumidAire 3i. Reattach the connector plug firmly
after you detach the HumidAire 3i.
ATTACH A HUMIDAIRE HUMIDIFIER
Please refer to the illustrations in section F of the illustration sheet.
To connect your
S8 COMPACT to a HUMIDAIRE humidifier you need medium sized
21” (52 cm) air tubing.
1 Fill the HUMIDAIRE water chamber and place inside the HUMIDAIRE. Connect the
medium 21” (52 cm) and long 6‘6” (2 m) air tubing (F-1), and close the humidifier lid.
2 Place the S8 COMPACT on top of the HUMIDAIRE (F-2) and connect the free end of
the medium air tubing to the air outlet (F-3).
Note: To avoid water spilling into the S8 Compact, do not put it underneath the
humidifier.
3 Assemble your mask system and connect it to the free end of the long air tubing (F-4).
4 Plug the HUMIDAIRE power cord into a power outlet. Connect the S8 COMPACT power
cord to the socket at the rear of the
S8 COMPACT and plug the other end into a power
outlet.
Please refer to the HumidAire User’s Manual for further details.
!
WARNING
Make sure that the power cord and plug are in good condition and the equipment
is not damaged.
The
S8 COMPACT is now ready for use with the HUMIDAIRE.
338249r1.book Page 10 Friday, June 10, 2005 3:22 PM
To Next Page
Loading...
Need help?
General
