19
Language
In this adjustment channel the menu language can be selected.
• DE : German
• EN : English
• FR : French
LANG
Language
Selection: DE, EN, FR
Factory setting: DE
19
20
20
Units
In this adjustment channel the temperature unit can be selected.
The unit can be switched between °C and °F during operation.
UNIT
Temperature unit
Selection: °C, °F
Factory setting: °C
21
21
OSDC 21
PUSH
LOGI
Log interval
Adjustment range: 1 … 1200 s
Factory setting: 60 s
OSDC
SD card
Selection: ON / OFF
Factory setting: OFF
21
SD card
The controller is equipped with an SD card slot for SD memory cards.
With an SD card, the following functions can be carried out:
• Logging measurement and balance values. After the transfer to a computer, the
values can be opened and visualised, e. g. in a spreadsheet.
While an SD card is being used, the symbol Ⓒ will be displayed. If the SD card
is full, Ⓒ will start ashing.
Starting the logging
Î Insert the SD card into the slot.
Logging will start immediately.
Î Adjust the desired logging interval LOGI.
When LLOG is activated, data logging will stop if the capacity limit is reached. The
message CFULL will be displayed.
With non-linear logging (when LLOG is deactivated), the oldest data logged onto
the SD card will be overwritten as soon as the capacity limit is reached.
Completing the logging process
Î Select the menu item REMC.
Î After --REM is displayed remove the card from the slot.
REMC
Safely remove card
Adjustment range: ON / OFF
Factory setting: OFF
LLOG
Linear logging
Adjustment range: ON, OFF
Factory setting: OFF
To Next Page
Loading...
Need help?
General
