REMstar Plus with C-Flex User Manual ❍ 7
System Features
AC Inlet ............................... Connect/disconnect the AC power cord here.
Air Outlet ............................ Connect the flexible tubing here.
Communications
Connector ............................ For clinical use with the Encore
®
Pro Data Management Software or an
IEC 950 approved device. Connect the communications cable here.
DC Inlet ............................... Connect the optional DC power cord here.
Display Screen.....................All system settings, total operating time, and therapy hours will appear
here. Displays the pressure and elevation settings.
Filter Cap & Filters ............ The foam filter screens out normal household dust and pollens. The
optional, ultra-fine filter is also included for more complete filtration of
very fine particles. The filter cap is designed to reduce the noise from
the REMstar Plus with C-Flex.
Humidifier Button ..............This button turns the REMstar heated humidifier on/off and allows the
heat setting to be adjusted. The humidifier is an optional accessory that
may be purchased separately.
Medical Product Note......... For ease at airport security stations, there is a note on the bottom of the
REMstar Plus with C-Flex stating that it is medical equipment. It may
help if you also take this manual with you when you travel.
Pressure Start / Stop
Button ................................ This button starts/stops the airflow.
Ramp Button ....................... This button starts the ramp cycle or accesses the REMstar Plus with
C-Flex settings.
User Buttons ........................ These buttons can be used to change some of the system settings.
AC Inlet
DC Inlet
Communications
Connector
Filter and
Filter Cap
Pressure
Start/Stop Button
Air Outlet
Ramp
Button
Humidifier
Button
Display
Screen
Medical
Equipment
Note (on bottom)
User Buttons
To Next Page