6.18 Transmit DTMF/5 Tone Signaling
6.19 Transmit Tone burst frequency
6.20 Transmit DTMF by Microphone Keypad
If the current channel is with DTMF/5TONE signaling, hold PTT and [UP] key will transmit
selected Pre-programmed signaling.
Hold PTT and [DOWN] key will transmit selected Pre-programmed tone burst frequency.
Hold PTT, then input DTMF signaling by the microphone keypad.
7. FUNCTION MENU
1. Hold [FUNC] key to enter SELECT MENU interface.
2. Short press [P4], [P6] key or turn channel knob to choose menu list. Short press [P5]
can fast turn page.
3. Press [PUSH] button to enter FUNC MENU setting.
4. Short press [P4], [P6] key or turn channel knob to choose wanted setting.
1. Enter FUNCTION MENU list, choose No.01 function.
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.
Off~5: 6 levels available.
Off: Turn off BEEP function.
4. Press [PUSH] button or [P3] key to store setting and exit.
1. Enter FUNCTION MENU list, choose No.02 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.
Total 9 Channel step size available: 2.5K,5K,6.25K,10K,12.5K,20K,25K, 30K and 50K.
4. Press [PUSH] button or [P3] key to store setting and exit.
7.1 Beep
7.2 FREQUENCY STEP SIZE SETUP
To Next Page
Loading...
