Retevis RT95 User Manual

14
RT95 UHF/VHF Two Way Radio
6.10 Channel Delete
6.11 CTCSS/DCS Encode and Decode Setup
6.12 CTCSS Scan
6.13 DCS Scan
1. In channel mode, turn the channel knob or microphone [UP]/[DOWN] key to choose an
unwanted channel.
2. Short press [FUNC] key to switch function group, choose the [PX] key dened as V/
M function, press this key together with [FUNC] key for 2 seconds, current channel is
deleted and automatical jump to next channel.
1. Short press [FUNC] to switch function group, choose the [PX] key defined as CDT
function.
2. Short press PX dened as CDT function, then repeatedly short press this key set the
currently channel if use CTCSS/DCS encode and decode.
3. When the LCD displays: RCDT:XXX, turn channel knob or press microphone [UP]/
[DOWN] key to choose if add CTCSS/DCS decode signaling to current channel. Press
[PUSH] button then turn channel knob or press microphone [UP]/[DOWN] key to
choose wanted CTCSS/DCS decode signaling.
4. When the LCD displays: TCDT:XXX, turn channel knob or press microphone [UP]/
[DOWN] key to choose if add CTCSS/DCS encode signaling to current channel. Press
[PUSH] button then turn channel knob or press microphone [UP]/[DOWN] key to
choose wanted CTCSS/DCS encode signaling.
5. CTCSS: 62.5-254.1Hz plus one self dene group. total 52 groups.
DCS: 000N-777I total1024 groups.
N is positive code, I is inverse code.
Press FUNC key can choose positive or inverse code.
6. Hold [PUSH] or [FUNC] key to store and exit, or wait 10 seconds the radio will
automatically store the setting and exit.
In channel or VFO mode, short press [FUNC] to switch function group, choose the [PX]
key dened as CDT function. short press this key to enter CTCSS code setting. when
the LCD displays CTC, long press this key to enter CTCSS scan. turn channel knob or
press microphone [UP]/[DOWN] key can change scan direction. Once nding a matching
CTCSS signaling, it will stop 5 seconds then scan again, short press any key to exit
CTCSS scan.
In channel or VFO mode, short press [FUNC] to switch function group, choose the [PX]
key dened as CDT function. short press this key to enter DCS code setting. When the
LCD displays DCS, long press this key to enter DCS scan, turn channel knob or press
microphone [UP]/[DOWN] key can change scan direction. Once nding a matching DCS
signaling, it will stop 5 seconds then scan again, press any key to exit DCS scan.
»
Under channel mode,this operation can be temporarily used by user. Once the
radio is turned off or switched to another channel, the temporary setting will be
erased. If the channel setting programmed for valid, the temporary setting will keep
valid until next change, turn off radio or switch to another channel, the temporary
setting will not changed.

Retevis RT95 Specifications

General

Channels	200
Frequency Stability	±2.5ppm
Frequency Range	VHF:136-174MHz
Voltage	13.8V DC ±15%
Channel Spacing	25kHz/12.5kHz
Operating Temperature	-20°C to +60°C