Select suitable bandwidth in accordance with different local conditions
1. Enter CHAN MENU list, choose No.7 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.
WID: band width is 25k(Wide band)
MID: band width is 20k(Middle band)
NAR: band width is 12.5k(Narrow band)
4. Press [PUSH] button or [P3] key to store setting and exit.
With this function on, the transceiver will be able to communicate with a transceiver in
same network without through a repeater.
1. Enter CHAN MENU list, choose No.8 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.
ON: Turn on reverse function
OFF: Turn off reverse function
4. Press [PUSH] button or [P3] key to store setting and exit
8.7 Band-width Selection
8.8 Frequency Reverse
»
This settting is valid only when CTCSS/DCS signaling added.
»
Frequency reverse is turn on, the TX and RX frequency will be exchanged, the
CTCSS or DCS signaling also will be exchanged if existed in current channel.
C/T: You can hear the calling when receives any matching carrier or CTCSS/DCS or
optional signaling.
4. Press [PUSH] button or [P3] key to store setting and exit.
»
This function is hide when RTDF function is on.
1. Enter CHAN MENU list, choose No.9 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
ON: Turn on talk around function
OFF: Turn off talk around function
4. Press PUSH button or P3 key to store setting and exit.
8.9 Talk Around
1. Enter CHAN MENU list, choose No.10 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting, press [FUNC] key to set the offset
direction.
8.10 Offset Freqeuncy And Direction Setup
To Next Page
Loading...
Need help?
General
