Retevis RT95 User Manual

22
RT95 UHF/VHF Two Way Radio
1. Enter CHAN MENU, choose No.4 function;
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.
0~99: Total 100 groups 5Tone encode for selection.
4. Press [PUSH] button or [P3] key to store setting and exit.
8.4 5TENC (5TONE ENCODE SELECT)
8.5 T-DEC (Add Optional Signaling)
»
5Tone group name and connect shall be programmed by PC software. If the
choose 5Tone encode has a group name, the LCD will display group name only.
»
The working of optional signaling shall be work associated with the squelch mode
setup. (Refer to Squelch Mode setup in page XX ).
3. Turn channel knob to choose wanted setting
HI: Choose high power level.
MI: Choose middle power level.
LO: Choose low power level.
4. Press [PUSH] button or [P3] key to store setting and exit
This transceiver has 2 optional signaling: DTMF/5Tone/. those signaling function similar
to CTCSS/DCS signaling. When the receiver adds an optional signaling, the caller
shall transmit matching signaling. DTMF and 5Tone signaling can be applied for other
advanced features such as ANI, PTT ID, group call, select call, remotely stun, remotely
kill waken…etc.
1. Enter CHAN MENU, choose No.4 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
DT: means DTMF signaling is added.
5T: means DTMF signaling is added.
OFF: Turn off optional signaling.
4. Press [PUSH] button or [P3] key to store setting and exit.
This function can improve the level of blocking irrelative signals.
1. Enter CHAN MENU, choose No.6 function.
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.
SQ:You can hear the calling when receive a mathcing carrrier.
CDT:You can hear the calling when receive a matchng carrier and CTCSS or DCS
signaling
TONE: You can hear the calling when receives matching carrier + optional signaling.
C&T: You can hear the calling when receives matching carrier + CTCSS/DCS + optional
signaling.
8.6 Signaling Combination Setup

Retevis RT95 Specifications

General

Channels	200
Frequency Stability	±2.5ppm
Frequency Range	VHF:136-174MHz
Voltage	13.8V DC ±15%
Channel Spacing	25kHz/12.5kHz
Operating Temperature	-20°C to +60°C