Retevis RT95 User Manual

18
RT95 UHF/VHF Two Way Radio
1. Enter FUNCTION MENU list, choose No.08 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
5S : It pauses 5s once scanning a matching signal, then resume scan
10S : It pauses 10s once scanning a matching signal, then resume scan
15S : It pauses 15s once scanning a matching signal, then resume scan
4. Press [PUSH] button or [P3] key to store setting and exit.
When turn off AOP, the radio need press
key to power on when connect with the
power supply.
1. Enter FUNCTION MENU list, choose No.09 function.
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
ON : Enable AOP function
OFF: Power off by manual
4. Press [PUSH] button or [P3] key to store setting and exit.
7.8 Scan Pause Time Setup
7.9 AOP (Automatic power on setup)
TO: It pause for preset pause time when scanning a matching signal, then resume
scan.
CO: It pauses once scanning a matching signal, and resume scan when signal
disappears.
SE: It stops once scanning a matching signal.
4. Press [PUSH] button or [P3] key to store setting and exit.
1. Enter FUNCTION MENU list, choose No.10 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting
ON: Enable Dual Watch function
OFF: Disable Dual Watch function
4. Press [PUSH] button or [P3] key to store setting and exit.
1. Enter FUNCTION MENU list, choose No.11 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose brightless level, 1-3 level available.
4. Press [PUSH] button or [P3] key to store setting and exit.
7.10 Dual Watch setup
7.11 Backlight Brightless Setup

Retevis RT95 Specifications

General

Channels	200
Frequency Stability	±2.5ppm
Frequency Range	VHF:136-174MHz
Voltage	13.8V DC ±15%
Channel Spacing	25kHz/12.5kHz
Operating Temperature	-20°C to +60°C