Operating the machine
26
Fig. 6: Filling inside the device
Pos: 8.42 /00005 Ü berschriften/ 1.1.1 Überschrift en/111 Füllen – außerhalb des Gerätes @ 3\ mod_127971 6797287_9.doc @ 21477 @ @ 1
5.10.2 Fílling – outside the device
Pos: 8.43 /00010 Bedienungsa nleitungen Kapitels ammlungen/GM 200 (2010)/001 5 GM200N B edienung/1555 GM 200_2010 Mo dul Füllen außerhalb @ 3\ mod_12797217 06643_9.doc @ 21622 @ @ 1
The jug can also be filled before positioning in the device. This means that you can
work without problem with several jugs without intermediate cleaning.
The jugs can only be charged outside the machine with the 500ml and 1000ml lids;
the gravitation lid is not suitable for this purpose.
• Place the cutter cylinder into the jug.
• Add the sample material.
• Position the lid.
• Press the lid in the centre downwards and place the jug into the device.
In the case of the 500ml lid it is essential to push it down so that the cutter cylinder
reaches its final position.
Do not use the gravitation lid when filling the jug outside the machine since
otherwise the cutter will not interlock.
• Close the hood until it latches in the interlock pin.
To Next Page
Loading...