Retsch GM200 - Fault Messages and Troubleshooting Guide; Solutions for Common Error Codes

Fault messages
34
Pos: 10.1 /00005 Ü berschriften/ 1. Überschriften/ 1 Fehlermeld ungen @ 2\mod _12590565897 28_9.doc @ 1 7580 @ @ 1
7 Fault messages
Pos: 10.2 /00010 Bedienungsa nleitungen Ka pitelsammlungen/ GM200 (2010)/00 35 GM200N Fe hlermeldunge n/3505 GM200 _2010 Modul Fe hlermeldungen @ 3\mod_1 279783114219_ 9.doc @ 2185 0 @ @ 1
F01
Motor is not running
F02
Motor is switched off due to overload
Restart grinding process with small
feed quantity.
F03
Motor speed too low / high
F04
Hood open
F05
Braking time too high
F06
Motor overheated
Allow motor to cool and restart.
F07
Hood monitoring defective
Check the fault message:
Press the START button when the
hood is open.
The “time“ and "speed“ segment
displays flash evenly.
Close the hood to rectify fault.
F08
Overspeed through hardware
Pos: 11.1 /00010 Bedienungsa nleitungen Kapitels ammlungen/------- Seitenum bruch ----------- @ 0\mod_122234437375 8_0.doc @ 238 6 @ @ 1