01.12.2016 Retsch GmbH 23
Automatic stop
• Switch the automatic stop on or off.
The function only operates without errors if the machine load is constant
and is not too low, because load is the indicator for automatic stopping. If
the device switches off prematurely because the load is too low, it is
advisable to work without this function.
If the automatic stop has been switched on, the run-on time function
activates during operation with vibratory feeder.
Run-on time during operation with vibratory feeder
00:00:60 to 00:01:59 (hours : minutes : seconds)
When using a vibratory feeder, the run-on time of the device can be set
here if the automatic stop is active.
Language
You can select the menu language here. After selecting and pressing the
control knob, the entire menu structure is displayed in your language.
NOTICE
The language menu is displayed when the device is switched on for the first
time.
• Select the desired language by turning the control knob.
– Press to confirm the selection; “open lid” appears on the display.
Brightness
The brightness can be adjusted to suit the respective user or environment
(sunshine, glare etc.).
Date
The current date can be entered here.
The device can be disconnected from the mains for up to 30 days before
the settings are lost.
Time
The time can be entered here.
The time then appears in the stand-by monitor.
The device can be disconnected from the mains for up to 30 days before
the settings are lost.
Acoustic warning signal
Error messages indicating incorrect operation can be supported by an
acoustic warning signal. The corresponding pictogram appears if the
function has been switched off.
Service
Operating hours
Grinding hours are counted, i.e. the total times between START and STOP.
It is not possible to manipulate the times.
Software version of display
Shows the software version of the display.
To Next Page
Loading...