In the case of large volumes of grinding material, the
cyclone separator permits material discharge of up to
5000ml in a collecting receptacle.
It is also available with a 3000ml collecting receptacle.
The air throughput created in the ZM200 during the grinding
process causes the grinding material to be transported into
the collecting receptacle.
The air throughput depends on the mesh size of the ring
sieve.
Installation procedure
Place a slotted screwdriver on the housing recesses and
remove the two plastic plugs KS
Screw in 2x retaining bolts HB using an SW19 open end
wrench
Position the support and secure with 2x screws SC
Insert cassette with outlet DG in place of the standard
collecting receptacle with ring sieve and cassette lid
Close housing lid GD of the ZM200
Place the cyclone ZK in the shaft
Connect the cyclone and the cassette with outlet to the
coupling KP
Where necessary unscrew screws SC again and adjust
the height by moving the support. The cyclone adapter
and the collecting receptacle should be aligned.
Secure the collecting receptacle AB to the cyclone
Slide the hopper TR with the filter sack FS into the
cyclone
The height adjustment of the hopper TR influences the
degree of separation of the solid material/air mixture.
The best position in each case should be determined
empirically. The fact that the pipe end RE of the hopper TR
ends somewhat below the adapter ST for the material entry
into the cyclone may serve as a guide.
The ZM200 can now be started at the speed still to be
selected by you.
To Next Page
Loading...
