MINI Quick Start Guide
14 ©2023 REVOPOINT 3D ALL RIGHTS RESERVED
LED Indicators
Update the Firmware
When you connect your MINI to Revo Scan, a pop-up will notify you of
any firmware updates. If you want to update your firmware, follow the
install wizard’s prompts and ensure that your MINI has a stable power
supply.
Scanner Calibration
Your MINI 3D Scanner was calibrated in the factory and only needs to
be recalibrated after a year of use or if the scanned results do not
match the specified accuracy.
If you need to calibrate your MINI 3D scanner, please send messages
to our custmer service team, or you can visit our Forum to find the
calibration package and instructions.
Safety Maintenance Instructions
1. Small parts, such as markers and USB adapters, are dangerous if
swallowed. Keep all components out of reach of children and animals
to avoid serioud injury to them.
2. Store the scanner and all accessories in a cool, dry place away from
direct sunlight.
3. Do not allow the scanner to come into contact with or become
immersed in water or other liquids. If it gets wet, wipe them dry with a
To Next Page
Loading...
