Need help?Do you have a question about the REVV GENERATOR and is the answer not in the manual?
Details warranty obligations, including proof of purchase and authorization.
Lists conditions not covered by the warranty, such as misuse or unauthorized service.
Describes the ¼" instrument cable input jacks for active and passive pickups.
Details Channel One's clean mode, controls, and tone characteristics.
Explains Channel One's crunch mode, gain control, and EQ adjustments.
Covers Channel Two's gain, EQ, aggression, bright, fat, and contour controls.
Describes the two programmable master volume controls and their function.
Explains the global power amp controls for low-end (depth) and treble (presence).
Details accessory functions like Masters, Mute, FX Loop, and Store switches.
Explains the operation of the power and standby switches for amp activation.
Instructions for connecting the amplifier to the mains AC power receptacle.
Information on the main and HT fuses for overload protection and replacement.
Describes test points for setting the bias of power tubes without removing the chassis.
Explains fuses for power tubes and their role in protecting the amp.
Details the line out jack for connecting to other power amps or recording.
Covers speaker connections, impedance settings, and safe operation with cabinets.
Instructions for connecting external pedals or effects units to the FX loop.
Explains MIDI IN and THRU connections for external control and daisy-chaining.
Details the connection of the foot switch via Ethernet cable.
Describes the connection for Revv speaker cabinet lighting.
How to switch the serial FX loop on and off for applying effects.
Adjusting the send level for optimal signal to effects units.
Methods for engaging and disengaging the FX loop in the signal path.
Step-by-step guide on how to connect and use the effects loop.
Recommends specific power tubes and describes their tonal characteristics.
Explains how to mix power tubes and set bias for different pairs.
Identifies the preamp tubes used and their function.
Detailed instructions on how to bias the power tubes using a voltmeter.
Discusses MIDI IN connection and phantom power for external equipment.
Explains how to set the amplifier to respond to any MIDI channel.
Instructions for manually or automatically setting the amplifier's MIDI channel.
How to save and recall amplifier configurations using MIDI program changes.
Lists functions that can be controlled via MIDI, including program changes and CC commands.
Details CC numbers for controlling specific amplifier functions like channels and mute.
Instructions for connecting the foot switch to the amplifier using an Ethernet cable.
Explains how the foot switch buttons function in control mode.
How to save and recall amp settings as presets using the foot switch buttons.
How to switch between Control and Preset modes on the foot switch.
How to engage and disengage mute functionality using the foot switch.
Notes that mute cannot be saved to a preset bank.
Procedure to reset the foot switch memory to factory defaults.
Steps to clear the amp's memory and restore all settings to factory defaults.
General| Tubes | Yes |
|---|---|
| Power Output | 120 Watts |
| EQ | 3-Band |
| Footswitch | Yes |
| Effects Loop | Yes |
To Next Page
