Revv Owner’s Manual2.0
2.1
front panel layout
Input
¼” Instrument cable input.
Active Input – The active input jack is to
be used with guitars that have active
pickups and work better with lower
impedance than a guitar with passive
pickups. Because active pickups don’t
require high impedance and usually
provide a stronger signal out, this jack
provides the proper circuit in order to
keep the tone of the amp articulate
and preventing unwanted compression
and noise.
Passive Input – The passive input jack is
to be used with guitars that have passive
pickups and require high impedance for
proper signal transfer. This jack is de-
signed to get the strongest signal from a
passive pickup to the first tube stage.
2.2
Channel One (Clean)
Selected by: 1) pushing the designated
front panel momentary toggle switch up,
2) foot switch button #1 or a foot switch
preset mode setting, 3) MIDI and CC
commands.
Channel One CLEAN is equipped with a
treble, mid, bass and level control. The
passive EQ controls have a large range
for all different clean variations and
should be adjusted a little at a time while
C
H 1
C
To Next Page
Loading...
