REXON M2503R - Additional Miter Saw Safety Rules; Material, Blade, and Guard Safety; Operator Training and PPE; Operational Safety Practices

2
manufacturer. Do not use HSS (High
Speed Steel) blades or any other blade
that does not conform to EN847-1.
Damaged, warped or deformed blades
should not be used.
3. Do not use the saw without the guards
in position, in good working order and
properly maintained.
4. Replace the table insert when worn.
5. Connect your miter saw to a dust
collecting device when sawing.
6. Check the maximum depth of cut.
7. When sawing long work pieces,
always use additional supports and
clamping devices.
8. Always wear ear protection,
safety glasses or goggles and a
breathing mask.
9. The operator must be adequately
trained in the operation of miter saws
and their components.
10. Wear suitable personal protective
equipment when necessary, this
could include:
●
hearing protection to reduce the risk
of induced hearing loss;
●
eye protection;
●
respiratory protection to reduce the
risk of inhalation of harmful dust;
●
gloves for handling saw blades
(saw blades shall be carried in a
holder wherever practicable) and
rough material.
WARNING!
●
Ensure that the arm is securely xed
when bevelling;
●
Keep the oor area around the
machine level, well maintained and
free of loose materials e.g. chips and
cut-offs;
●
Use correctly sharpened saw blades.
●
Observe the maximum speed marked
on the saw blade;
●
When tted with laser, no exchange
with different type of laser is
permitted. Repairs shall only be
carried out by the laser manufacturer
or an authorised agent. Refrain from
removing any cut-offs or other parts
of parts, mounting and any other
conditions that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced
by an authorised service centre unless
otherwise indicated in this instruction
manual. Do not use the tool if the switch
does not turn it on and off.
21. WARNING. The use of any accessory
or attachment other than one
recommended in this instruction manual
may present a risk of personal injury.
22. HAVE YOUR TOOL REPAIRED BY
A QUALIFIED PERSON. This electric
tool complies with the relevant safety
rules. Repairs should only be carried
out by a qualied person using original
spare parts, otherwise this may result in
considerable danger to the user.
23. THROUGH POOR CONDITIONS OF
THE ELECTRICAL MAINS, shortly
voltage drops can appear when starting
the EQUIPMENT. This can inuence
other equipment (e.g. blinking of a
lamp). If the MAINS-IMPEDANCE
Zmax < 0.34 OHM, such disturbances
are not expected.
24. DO NOT USE SAW BLADES
MANUFACTURED FROM HIGH
SPEED STEEL.
25. KEEP THE FLOOR AREA AROUND
THE MACHINE LEVEL, well maintained
and free of loose material e.g. chips
and cut-offs.
26. USE CORRECTLY SHARPENED SAW
BLADES. Observe the maximum speed
marked on the saw blade. Ensure that
the machine is always xed to a bench,
whenever possible.
Additional Safety Rules for
Miter Saws
1. This saw is recommended for cutting
wood, non-ferrous material and
plastic only.
2. Select saw blades in relation to
the material to be cut and only use
blades that are recommended by the