Need help?Do you have a question about the REXON SM2158R and is the answer not in the manual?
Describes how to carefully remove and check all parts from the carton.
Keep work area clear, consider environment, ensure good lighting, avoid wet conditions.
Dress properly, use protective equipment, secure work, maintain balance.
Do not force the tool, use the right tool, maintain tools, disconnect tools safely.
Guard against electric shock, avoid mains impedance issues, use outdoor extension leads.
Do not use HSS blades, use guards, replace table insert, connect dust extraction.
Operator must be trained, wear suitable PPE like hearing, eye, and respiratory protection.
Ensure arm is fixed, keep floor clear, use sharp blades, observe speed, fix to bench.
Always use designated carrying handle, avoid flammable liquids, remove nails, use safe cleaning solvents.
Explains various symbols used in the manual for safety and operation.
Identifies and labels all parts of the miter saw as shown in Figure 1.
Details motor power, voltage, frequency, and insulation type for the saw.
Lists blade size, bore, tooth count, turntable diameter, and angle ranges.
Outlines the maximum dimensions for cross cuts, miter cuts, bevel cuts, and compound cuts.
Instructions on safely transporting the saw and locking the cutting head.
Steps to install the miter handle onto the saw base using screws.
Guide for attaching the dust bag assembly to the saw's exhaust port.
How to install the hold-down clamp and rear extension support bar.
Instructions to unlock the slide carriage and store the blade wrench.
Steps to remove and reinstall the table insert for maintenance or cleaning.
Guides for adjusting the 0° and 45° bevel stops for accurate cuts.
Procedures for adjusting the miter table, pointer, and fence squareness.
Setting cutting depth/height limits and operating the laser guide.
Adjusting the lever to ensure the miter table locks securely.
How to check if the laser line is correctly aligned with the saw blade.
Steps to adjust the laser line's vertical and horizontal position using knobs.
Checks for power supply compatibility, grounding, and mains impedance.
Advice on selecting and using extension leads for optimal power and safety.
Instructions for securely mounting the saw to a workbench or plywood base.
Guidelines for holding workpieces, positioning, and hand safety.
Instructions on using the trigger switch and managing the sliding fence.
Operating slide carriage, setting miter cuts, and using quick-cam lock.
How to perform bevel, compound, and base molding cuts.
Tips for accurately cutting crown molding with compound angles.
Step-by-step guide for safely removing and installing a new saw blade.
Routine cleaning with a cloth and oiling rotary parts.
How to inspect and replace motor brushes for optimal performance.
To Next Page
General
