REXON SM2158R - Adjusting Laser Line Position; Connecting to the Power Supply; Power Supply Requirements; Extension Lead Usage

14
6. Looking at the front of the board,
if the laser line is not parallel to
the “pattern line” please follow the
instructions listed below under
“Front Line” paragraph.
7. Looking at the top of the board,
if the laser line is not parallel to
the “pattern line” please follow the
instructions listed below under “Top
Line” paragraph.
B. Adjusting the Position of the
Laser Line (Fig. 20, 21, 22)
Front Line (Fig. 20, 21)
If the laser line is angled from left to
right, turn the laser vertical adjustment
knob (1) counterclockwise to align the
laser line parallel with pattern line. If
the laser line is angled from right to left,
turn the knob clockwise to align the
laser line parallel with pattern line.
Top Line (Fig. 20, 22)
If the laser line is angled from left
to right, turn the laser horizontal
adjustment knob (2) clockwise to align
the laser line parallel with pattern line.
If the laser line is angled from right to
left, turn the knob counterclockwise
to align the laser line parallel with
pattern line.
After performing the above
adjustments, visually check that both
the front and top laser lines are parallel
with pattern line.
Check that the power supply and plug
used is in accordance with your miter
saw. Have a look at the rating plate
of the motor or the rating on the miter
saw. Any changes should always be
carried out by a qualied electrician.
If not properly earthed this machine
can cause an electrical shock. Be sure
that the power supply outlet is earthed.
If there is any doubt, have it checked
by a qualied electrician.
USING AN EXTENSION LEAD
The use of any extension lead will
cause some loss of power. To keep
this to a minimum and to prevent
overheating and motor burn-out, ask
advice from a qualied electrician to
determine the minimum wire size of the
extension lead.
The extension lead should be equipped
with an earthed type plug that ts the
power supply outlet at one end, and
with an earthed type socket that ts the
plug of this machine at the other end.
If the power cable is broken, repair
service is abailable at your nearest
service center.
Connecting to the Power Supply
WARNING! Avoid contact with the
terminals on the plug when installing
(removing) the plug to (from) the
power supply outlet. Contact will
cause a severe electrical shock.