3
11. Make sure there is adequate lighting
provision for your work area.
12. The laser tted onto this miter saw is
only designed for this saw. The tting
of any external, additional or different
type of laser is not permitted. Repairs
should only be carried out by authorised
repair agents.
13. Refrain from removing any cut-offs
or other parts of the workpiece from
the cutting area whilst the machine is
running and the saw head is not the rest
position.
14. Never stand on this tool as damage to
saw or serious injuries could result.
15. Never use the miter saw near ammable
liquids, vapors, or gases.
16. Remove all nails that may be in the
workpiece to prevent sparking that could
cause a re.
17. To avoid re or toxic reaction, never
use gasoline, naphtha acetone, lacquer
thinner or similar highly volatile solvents
to clean the miter saw.
18. Keep the saw with proper footing on a
table to decrease noise and vibration.
19. Always use the designated carrying
handle for transportation.
20. Never use the miter saw to make miter
cutting, bevel cutting or compound
cutting on metals.
SYMBOLS
V ……....volts A …....…...........amperes
Hz ….….hertz W ...........................watts
min …....minutes ~ .......alternating current
h …........hours ...Class II Construction
I ………..ON O ….….....................OFF
min
-1
…......revolutions per minute
Keep hands away from blade:
Failure to keep your hands
away from the blade will result in
serious personal injury.
WARNING! To reduce the risk of
injury, user must read instruction
manual.
Wear safety goggles.
Wear ear protection.
Wear a breathing mask.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead
of disposing of them as waste.
All tools, hoses and packaging
should be sorted, taken to the local
recycling center and disposed of in an
environmentally safe way. Do not dispose
of electrical appliances as unsorted
municipal waste, use separate collection
facilities. Contact your local government for
information regarding the collection systems
available. If electrical appliances are
disposed of in landlls or dumps, hazardous
substances can leak into the groundwater
and get into the food chain, damaging your
health and well-being. When replacing
old appliances with new once, the retailer
is legally obligated to take back your old
appliance for disposal at least for free
of charge. Disposal of discarded material
shall be in accordance with local
environmental regulations.
of the workpiece from the cutting
area whilst the machine is running
and the saw head is not in the
rest position;
●
Ensure that the machine is always
xed to a bench, whenever possible.
To Next Page
Loading...
