REXROTH Fe Series - Page 28

1: FM1 outputs 4...20 mA or 2...10 V, FM2 outputs 4...20 mA or 2...10 V
2: FM1 outputs 0...20 mA or 0...10 V, FM2 outputs 4...20 mA or 2...10 V
3: FM1 outputs 4...20 mA or 2...10 V, FM2 outputs 0...20 mA or 0...10 V
E09 setting range：
0: Output frequency
1: Output voltage
2: Output current
3: Set frequency
E16...E18 setting range：
0: Running
1: Frequency level detection signal 1 (FDT1)
2: Frequency level detection signal 2 (FDT2)
3: Frequency arrival signal (FAR)
4: Reserved
5: Under voltage
6: Overload (O.L.)
7: Reserved
8: Zero speed (lower than starting frequency)
9: E-Stop
10: Low voltage
11: No trip action
12: Error
13: Programmable program running
14: Programmable program run
15: Run for one stage
16: Over current stall
17: Over voltage stall
18: In forward rotation command indication
19: In reverse rotation command indication
20: Zero speed (incl. stop)
21: Being braked
22: Accelerating
23: Decelerating
24: Fan action
25: Reserved
Bosch Rexroth AG
Parameter Settings
24/31
DOK-RCON01-FE*********-IN04-EN-P