REYHEE CRUISER - Installing the Battery Pack; Installing the Upper Seat Post

Step ve: Installing the upper seat post into the lower seat post
Keep all body parts and any dangling items AWAY from any assembly
connection points, to prevent potential injury.
Upper seat post (which has 4 holes)
Seat post support ring (black ring with handle & twist screw)
Locate:
a)
b)
1)
Detent pin
Lower seat post knob
c)
d)
Step four: Installing the battery pack onto the battery terminal
Warnings:
If there is any damage, bulging, or exposure observed on the battery pack or
battery terminal, STOP immediately, DO NOT touch any part of the battery
pack or battery terminal, and contact customer support.
Read, comprehend, and follow ALL warnings and safety instructions in this user
manual BEFORE proceeding with this step.
Locate the battery pack.
Locate the battery terminal (which is where the battery should be placed at the
assembly point where the main body is afxed to the rear section).
•
•
1)
2)
Ensure the battery pack is facing the correct direction (with the curved side towards
the lower seat post).
3)
Firmly grip the battery pack handle from the top with both hands. Ensure steady
footing, then carefully lift the battery pack and place it onto the deck.
4)
Brace your feet rmly on the ground on either side of the deck (or on top of the
deck). Firmly grip the battery pack handle from the top with both hands. Carefully
lift the battery pack and place it directly on the battery terminal, ensuring alignment.
5)
DO NOT slide or drop the battery pack onto the
terminal, to prevent potential product damage.
Ensure hands are DRY before touching the battery pack or battery terminal, as
wet hands may cause electric shock.
Ensure that the Cruiser is powered OFF, rear lever is in DRIVE mode, and the
key is REMOVED from the ignition. (This will help prevent accidental starts or
movements of the Cruiser during assembly.)
•
•
Assembly (Cont.)
15