Warnings / Cautions / Compliance
9450 Duolink Exit Alarm Receiver Hardware Installation Guide Page 3 of 30
0510-1103-G
Warnings / Cautions / Compliance
It is important for your facility to implement and enforce the following WARNINGS and CAUTIONS in
order to keep all equipment functioning properly. Disregarding the information and instructions in this
document is considered abnormal use and may result in injury or system failure.
ACCESSORIES (SUPPLIES)—To ensure resident safety and proper
operation of equipment, use only parts and accessories manufactured or
recommended by RF Technologies, Inc. Parts and accessories not
manufactured or recommended by RF Technologies, Inc. may not meet
the requirements of the applicable safety and performance standards.
Failure to use the components and supplies specified by RF
Technologies, Inc. may result in equipment and/or system failure.
EXPLOSION HAZARD—These devices should not be used in the
presence of flammable gas mixtures. It should also not be used in oxygen
enriched atmospheres.
INSTALLATION AND CONFIGURATION—It is the responsibility of the
facility to follow the installation instructions carefully, as outlined in the
applicable system guides, and to use the components and supplies
specified by RF Technologies, Inc. for all installations.
Failure to use the components and supplies specified by RF
Technologies, Inc. may result in equipment and/or system failure.
INSTRUCTIONS FOR SET UP AND USE—It is the responsibility of the
facility to follow the instructions for set up and use carefully, as outlined in
this manual, and to use the components and supplies specified by RF
Technologies, Inc. for set up and use. Do not attempt to use extension
cords or other equipment not supplied by RF Technologies, Inc.
Failure to use the components and supplies specified by RF
Technologies, Inc. may result in equipment and/or system failure.
STATIC DISCHARGE—Do not touch the conductor portion of any
conductor or port. Damage to the device may result.
SYSTEM WIRING—All permanent supply connections must be done in
accordance with National Electric Code, NFPA 70.
To Next Page
Loading...