Warnings / Cautions / Compliance
9450 Duolink Exit Alarm Receiver Hardware Installation Guide Page 5 of 30
0510-1103-G
WORN OR DAMAGED PARTS—If the control unit pads or cables are
worn or damaged, you must have the product serviced. For more
information, see the section entitled “Service and Return.”
DISPOSAL—At the end of their service life the products described in this
manual, as well as accessories (i.e. lithium batteries, banding material,
disposable pads, etc.), must be disposed of in compliance with all
applicable federal, state and local guidelines regulating the disposal of
products containing potential environmental contaminants. Dispose of the
packaging material by observing the applicable waste control regulations.
RESIDENT GENERATED ALARMS—Do not rely exclusively on resident
generated alarms for resident care and safety. The alarm function of
equipment in the possession of residents must be verified periodically and
regular resident surveillance is recommended.
RESIDENT MONITORING—The most reliable method of resident
monitoring combines close personal surveillance with correct operation of
monitoring equipment. It is the responsibility of the facility to periodically
check on residents in possession of RF Technologies, Inc.'s equipment
(i.e. Pendants, Pull Cords, Control Units) to mitigate risk of inappropriate
use of equipment or strangulation and stumbling hazards from cables and
cords.
PRODUCT WARRANTIES—Failure to follow the Warnings and Cautions
in this guide voids any and all Product Warranties.
Do not use Pendants with people that have sensitivities or allergies to
device materials. The device materials include Acrylonitrile butadiene
styrene (ABS), Silicon, Rubber, and Neoprene.
Bio-
Incompatibility
Notice
UL 294
UL294 Access Control Performance Levels:
Destructive Attack Level I
Line Security Level I
Endurance Level IV
Standby Power Level I
To Next Page
Loading...