IKONIC Tankless Water Heater Service Manual
70
FLAME AND IGNITER ROD GASKET
HOW TO REMOVE COMPONENTS
1. Remove the hook lm part of the Over Heat Limiter
(OHL ). DO NOT cut the lm.
2. Remove flame and igniter rod wires from the rods.
3. Remove 3 screws from flame and igniter rod bracket,
and pull the flame and igniter rods
4. The gasket is located between the heat exchanger
and flame rod bracket.
NOTE: The spare gasket is located at lower left in the
unit.
Flame Rod
Igniter Rod
To Next Page
Loading...
