30
required heating load. Comfort mode provides a steady
cycles.
Flue Monitor – Flue Temperature Monitoring
Select PVC when using PVC vent materials. For CPVC,
polypropylene or stainless steel vent materials use the
The Flue Monitor utilizes a temperature sensor in the
vent temperature approaches the limits of PVC or CPVC/
polypropylene vent materials.
Max Fan RPM
high altitude, for installations with long intake air ducting or
Select Disabled if the heater controls will not be used to
• 1 Speed – The control will close and open the Pump
Relay activating the pump contactor to turn the pump
on and off. The filter pump must be on before the
heater can fire.
• 2 Speed – The control will close and open the Pump
Relay to turn the pump on and off and trigger Low
High speed.
• 4 Speed
Pump Relay to turn the pump on and off (or to
enable and disable a pump with full time power).
The control will also power one of the Variable Pump
• Variable
Relay to turn the pump on and off (or to enable and
disable a pump with full time power). Variable Pump
motor.
Spa Heat Speed (Selection available only with Pump
Operation enabled and 2, 4 or Variable speed pump)
available options. Available options will be based on the
Pump Operation selected in the previous step. Spa Heat
lpm) to the heater.
Pool Heat Speed (Selection available only with
Pump Operation enabled and 2, 4 or Variable speed
pump)
available options. Available options will be based on the
Pump Operation previously selected. Pool Heat Speed
to the heater.
Filter Speed (Selection available only with Pump
Operation enabled and 2, 4 or Variable speed)
available options. Available options will be based on the
Pump Operation previously selected. Filter speed should
be set to provide the required turns for proper sanitation,
body of water volume and the scheduled pump on time.
Freeze Protect (Selection available only with Pump
Operation enabled)
control will monitor water temperature when in Remote
and Run Schedule modes. If the water temperature sensor
Valve Operation (Selection available only with Pump
Operation enabled)
water to either the pool or the spa.
Return Valve (Selection available only with Valve Operation
enabled).
to Pool or Spa.
Suction Valve (Selection available only with Valve
Operation enabled)
to Pool or Spa.
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED
To Next Page
Loading...
