48
12. INSTALLER SETUP RECORD
Factory Defaults or install a new control. It is also a helpful troubleshooting tool, allowing all setup parameters to be
viewed on a single page.
Installer Setup Item Write down or circle the Installer Setup setting Default Setting
Celsius or Fahrenheit Fahrenheit
Spa Max Temp
Pool Max Temp
Pool Fan Mode Eco / Turbo Turbo
Spa Fan Mode Eco / Turbo / Comfort Turbo
Flue Monitor PVC / CPVC/PP / OFF PVC
Max Fan RPM
Pump Operation
Variable Disabled
Spa Heat Speed Disabled
Pool Heat Speed Disabled
Filter Speed Disabled
Freeze Protect Enabled (with Pump Operation)
Valve Operation
Disabled (only available with pump
operation enabled)
Return Valve
Suction Valve
Valve Change Delay Disabled
OFF
OFF
Low Temperature Lockout Enabled
EcoNet Address
Control Lockout PIN
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED
To Next Page
Loading...
