6
3. BEFORE INSTALLATION
Receiving Equipment
The manufacturer recommends that this manual be
reviewed thoroughly before installing your pool/spa
heater. If there are any questions that this manual does
not answer, please contact the factory or your local
representative.
On receipt of your equipment it is suggested that you
visually check for external damage to the carton. If the
carton is damaged, a note should be made on the Bill
of Lading when signing for the equipment. Remove the
heater from the carton. If it is damaged, report the damage
to the carrier immediately. Save the carton.
These items are shipped inside a box in the carton with
Bonding lug with mounting screw
PVC/Polypropylene/Stainless Steel vent adapter
8.
Be sure that you receive the number of packages indicated
on the Bill of Lading.
serial numbers of the heater. See Figure 2 for location of
you must also specify date of installation.
2" NPT ADAPTER
O-RING
2" SLIP TAILPIECE
UNION LOCKRING
BONDING LUG
W/ MTG SCREW
UNION P/N 015464F
BYPASS ASSEMBLY
P/N 015459F
P/N 015451
F10317
FLUE ADAPTER
P/N 015508F
WASHER
MOUNTING
SCREW
F10318
Figure 1. Standard Unit
MODEL & SERIAL
NO. LOCATED ON
RATING PLATE
MODEL & SERIAL NO.
CAN ALSO BE FOUND
INSIDE THE UNIT ON THE
SERIAL
NUMBER
F10319
Figure 2. Serial No. Location
indoor or outdoors. The heat exchanger bears the ASME
Ambient Temperature Rating
•
•
to operate properly. Frozen condensate may damage
exposure to freezing temperatures.
Elevation
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED
To Next Page
Loading...
