34
Remote Control Wiring
Important Installation Notes for Remote or External
• Remote wiring must be run in a separate conduit.
• Remote wiring must not be run parallel to high
voltage lines.
•
mm) lay and jacketed.
•
jacketed.
•
•
Please refer to the wiring instructions.
NOTE: The remote wires must be connected to the
7-pin connector BEFORE the connector is plugged into
the board.
This application assumes that only one heating function
(pool or spa) is required.
Turn on power to the heater.
mode and set the temperature to the highest setting
available on the control. The actual setpoint will be
controlled by the remote control.
from the heater.
and connect the other side to either the ORANGE/
Attach wire nut on unused wire to the “Remote
P8 Connector
ORN/BLK - To Spa (COMM)
Wire Nut - BLK/ORN
BLU - 24VAC
Figure 36. 2-Wire Remote Control
3-Wire Remote Control Using
Three-Position Switch (Pool-
This application assumes that both heating functions (pool
and spa) are required.
Turn on power to the heater.
from the heater.
P8 Connector
ORN/BLK - To Spa (COMM)
BLK/ORN - To Pool (COMM)
BLU - 24VAC
Figure 37. 3-Wire Remote Control
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED
To Next Page
Loading...
