EasyManua.ls Logo

Rheem Raypak X94 SR-410 - Page 32

Rheem Raypak X94 SR-410
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
Display Condition
 
 
Valve Chng Delay 󰀨
High Heating Second stage heat is running with EXT HEAT Aux mode
Heating Heater is operating
Spark Ignition control is running spark
Post Purge 
 
External Heat 
No Demand 
 
 ROM CRC failure on digital control board
 RAM failure on digital control board
 A/D Reference failure on digital control board
 A/D Multiplexor failure on digital control board
Aux Ctrl Fault 8 
 ROM CRC failure on Ignition Control Board
 RAM failure on Ignition Control Board
 A/D failure on Ignition Control Board
 Flame sense circuit failure on Ignition Control Board
 Out of sequence execution detected on Ignition Control Board
 
Remote Error Both Spa and Pool inputs are energized
 
 
Blocked Vent 
Vent Temp Limit Vent Temp Limit switch is open
Clock/Fireman Sw Clock/Fireman switch is open (Not stored in EEPROM)
Air Flow Sw Open Air Pressure Switch open with inducer on
Air Flow Sw Closed 󰀨
󰀨 󰀨
Fan Lockout 
Ignition Failure 
 
Ignition Lockout Ignition trial failed on Propane
MV Output Fault Ignition control has detected problem with gas valve output
Flame w/o CFH 
Low Temp Lockout 
EEPROM Fault Corrupted data found on the Digital Control Board
Ign EEPROM Fault Corrupted data found on the Ignition Control Board
Low Voltage 
Flue Over Temp 󰀨
Flue Sense Fail Flue Monitor is enabled and Flue temperature sensor is open or shorted
Blocked Drain Condensate drain switch is closed
Fan RPM Fault 󰀨
Table N. Error Condition Messages
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED

Table of Contents

Related product manuals