RHOSS Yardy EV3 - Section II: Installation and Maintenance; Transport, Handling, and Packaging; Storage and Positioning Requirements

13
Section II :: Installation and maintenance
EN
Packaged units can be stored by stacking a maximum of four
on top of each other and must be stored in a dry area.
Yardy-EV3 - Yardy-I EV3
MVP version
MVT version
MXP version
All the operations listed below must be carried out in accordan-
ce with current health and safety regulations, with reference to
the equipment used as well as the procedures followed. Before
commencing handling operations, ensure that the lifting device
has the required capacity for the unit in question.
The units can be moved or lifted by hand or by means of a
suitable truck. If the unit weighs more than 30 kg and is to be
handled manually, this must be carried out by two persons: ho-
wever, it is recommended to use a truck. If several units need
to be moved at the same time, it is advisable to put the machi-
nes in a container and lift them by means of a crane or similar
vehicle.
)ROORZWKHVHLQVWUXFWLRQVWRUHPRYHWKHSDFNDJLQJ
II. SECTION II :: INSTALLATION AND MAINTENANCE
INSTRUCTION FOR TRANSPORT
3DFNDJLQJDQGFRPSRQHQWV
Handling guidelines
6WRUDJHFRQGLWLRQV
&OHDUDQFHDQGSRVLWLRQLQJ
• Check for any visible damage;
• Open the packaging;
• Check that the envelope containing the use and maintenance
manual is in the packaging;
• Remove the packaging material and dispose of it in the ap-
propriate collection points or recycling facilities, in compliance
with the regulations in force.
!
DANGER!
Do not leave the packaging within reach of children.
!
DANGER!
Movement of the unit must be performed with care, in order to avoid
damage to the external structure and to the internal mechanical and
electrical components. Also make sure that there are no obstacles or
people along the route, in order to prevent the risk of impact, crushing
or tipping the lifting device. Always use personal protective equipment.
SAFEGUARD THE ENVIRONMENT
Dispose of the packaging materials in compliance with the national or
local legislation in force in your country.
IMPORTANT!
Incorrect positioning or installation of the unit may amplify noise levels and
vibrations generated during operation.
MXT version
IVP version IVF version
IXP, DUCT and ID2 version
150
150
100
150
150
150
100
150
150
150