Ricoh 1075 - Important

4
Important
When the machine is connected to a network, observe the following points when
setting up the machine or changing settings.
For more details, see the documentation and Help for ScanRouter V2 Lite/Pro-
fessional and DeskTopBinder V2 Lite/Professional.
❖
❖❖
❖ When a dial-up router is connected in a network environment
The settings for the delivery server to be connected must be made appropri-
ately for the machine with ScanRouter V2 Lite/Professional, ScanRouter V2
Link, or DeskTopBinder V2 Lite/Professional. In addition, appropriately set
up connected devices with the I/O settings of ScanRouter V2 Administration
Utility.
If the network environment changes, make the necessary changes for the de-
livery server with the machine, administration utility of client computers,
ScanRouter V2 Link, and DeskTopBinder V2 Lite/Professional. Also, set the
correct information for the connected device with the I/O settings of Admin-
istration Utility.
Important
❒ When the software is set up to connect to the delivery server via a dial-up
router, the router will dial and go online whenever connection to the deliv-
ery server is initiated. Telephone charges may be incurred.
❖
❖❖
❖ When connected to a computer that uses dial-up access
• Do not install ScanRouter V2 Lite/Professional on a computer which uses
dial-up access.
• When using ScanRouter V2 Lite/Professional, DeskTopBinder V2
Lite/Professional, ScanRouter V2 Link, or TWAIN driver on a computer
with dial-up access, dial-up may be performed when connecting to the de-
livery server and other equipment, depending on the setup. If the compu-
ter is set up to connect to the Internet automatically, the confirmation
dialog box will not appear, and telephone charges may be incurred with-
out the user being aware of it. To prevent unnecessary dial-ups, the com-
puter should be set up so that the confirmation dialog box is always
displayed before establishing a connection. Do not make unnecessary dial-
ups when using the above listed software.
❖
❖❖
❖ When working in a WAN environment
In a WAN environment, do not use the ScanRouter V2 Link or other admin-
istration utility installed on a client computer. In some network environ-
ments, time-out may occur and normal delivery may not be possible.
❖
❖❖
❖ When connected to a mail server
When the machine is connected to an SMTP server managed by an Internet
service provider (hereafter called “Provider(s)”), the POP identity (POP Be-
fore SMTP) may be required by the Provider. When the machine is connected
to an SMTP server through a direct dial-up connection with the Provider, the
POP identity (POP Before SMTP) is not required.