Ricoh 3030 - Sending Scan Files by Scan to Folder; Procedure for Sending by Scan to Folder

Sending Scan Files by Scan to Folder
33
3
Sending Scan Files by Scan to Folder
Procedure for Sending by
Scan to Folder
A scan file is sent after scan settings
and destinations are specified.
A Press the {Scanner} key.
Note
❒ The illustration is an example.
The actual appearance may be
different.
B Make sure that no previous set-
tings remain.
Note
❒ If a previous setting remains,
press the {Clear Modes} key.
C Place originals.
Reference
The procedure for placing origi-
nals is the same as that for plac-
ing originals for copying. For
details about placing originals,
see “Placing Originals”, Copy
Reference.
D Make settings for original orien-
tation, the sides scanned, and oth-
er settings if necessary.
Reference
p.79 “Making the Settings Relat-
ed to the Orientation of the
Original and Scanned Sides”
E Make the scan settings.
Reference
There are two ways to specify
scan settings, as described be-
low:
• Configure each setting for
scanning. For details, see
p.77 “Specifying Scan Set-
tings”.
• Recall registered settings. For
details, see p.86 “Recalling a
Program”.
F If the network delivery scanner
screen appears, switch to the Scan
to Folder screen.
A Press [].
B Press [Switch Destination List].
C Press [E-mail].
D Press [Exit].
The e-mail screen or the scan to
folder screen appears.
E If the e-mail screen appears,
press [].
The Scan to Folder screen ap-
pears.
ZZZ607S