Ricoh 3030 - Recalling a Program; Changing a Registered Program; Deleting a Program

Configuring/Registering Scan Settings
86
7
Recalling a Program
A Make sure the {Scanner} key is se-
lected, and then press the {Pro-
gram} key.
B Press [B Recall].
C Press the number of the program
you want to recall.
The registered settings are dis-
played.
Note
❒ Programs are not registered in
numbers that appear without
m.
D Place the originals, and then press
the {Start} key.
Changing a Registered
Program
A Make sure the {Scanner} key is se-
lected, and then press the {Pro-
gram} key.
B Press [B Recall].
C Press the number of the program
you want to change.
D Change settings of the program.
E Press the {Program} key.
F Press [m Register].
G Press the number of the program
for which you changed settings or
the number of a different pro-
gram in which you want to regis-
ter the changed settings.
H If you select a program that is al-
ready registered, aconfirmation
message appears. To overwrite
the program, Press [Register].
Note
❒ If no program is registered un-
der the number you select, skip
to step
I
.
I Enter a program name.
J Press [OK].
Note
❒ If you register a program in a
number that is already regis-
tered, the old program is over-
written.
Deleting a Program
A Make sure the {Scanner} key is se-
lected, and then press the {Pro-
gram} key.
B Press [Delete].
C Press the number of the program
you want to delete.