Ricoh 3030 - Simultaneous Storage and Sending by E-Mail

Sending Scan Files by E-mail
27
2
❒ To interrupt scanning, press the
{Clear/Stop} key or press [Stop]
on the display panel.
❒ When placing multiple origi-
nals one-by-one, place the next
original. For details, see p.82
“Scanning Originals in Several
Times”.
Simultaneous Storage and
Sending by E-mail
You can use the e-mail function and
the storage function together.
The scan file is sent by e-mail and at
the same time is stored.
Note
❒ This section explains mainly the
procedure for simultaneous stor-
age and sending of e-mail. For de-
tails, see p.17 “Procedure for
Sending E-mail”.
❒ The file stored when simultane-
ously storing a file and sending it
by e-mail cannot be resent in the e-
mail screen. To resend the file, se-
lect the file in the [Select Stored File]
screen and send it. See p.54 “Send-
ing Stored Files by E-mail or Scan
to Folder, or Delivering”.
A Place originals.
Note
❒ The procedure for placing origi-
nals is the same as that for plac-
ing originals for copying. For
details about placing originals,
see “Placing Originals”, Copy
Reference.
B Make settings for original orien-
tation, the sides scanned, and oth-
er settings if necessary.
Reference
p.79 “Making the Settings Relat-
ed to the Orientation of the
Original and Scanned Sides”
C Make the scan settings.
Note
❒ There are two ways to specify
scan settings, as described be-
low:
• Configure each setting for
scanning. For details, see
p.77 “Specifying Scan Set-
tings”.
• Recall registered settings. For
details, see p.86 “Recalling a
Program”.
D Specify the destination.
E Specify the sender and a subject.
F Press [Store File].
G Make sure [Send & Store] is select-
ed.