Sending Scan Files by Scan to Folder
35
3
Using a registration number to
select a destination folder
A Press [Registration No.].
B Enter the five digit registration
number that has been assigned
to a destination folder using
the number keys.
If the entered number is less
than five digits, press the {#}
key after the last number.
Example: To enter 00003
Press the {3} key, and then
press the {#} key.
Note
❒ If a protection code has been
set for the shared folder, a
screen for entering the pro-
tection code appears.
C To select more destination
folders, repeat step AaB.
Note
❒ To deselect a destination,
press [UPrev.] or [TNext] to
display the destination in the
destination field, and then
press the {Clear/Stop} key.
Directly enter the path for the
folder of a client computer on the
same network
A Press [Enter Destination].
B Press [SMB].
Note
❒ If you try to switch to a pro-
tocol from one for which
[Path], [User Name] or [Pass-
word] is specified, a message
asking you to confirm the
protocol change appears.
C Press [Manual Input] on the right
side of the path field.
The soft keyboard appears.
D Enter the path for the folder.
Note
❒ For details about the maxi-
mum number of characters
that can be entered, see p.123
“Scan to Folder”.
❒ The following is an example
of a path where the folder
name is “user” and the com-
puter name is “desk01”:
\\desk01\user
❒ An IP address can also be en-
tered if you use one of the fol-
lowing operating systems :
Windows 98/Me/XP/2000,
Windows NT 4.0 or Win-
dows Server 2003.
To Next Page
Loading...
