Log Information and Deleting Data on the Hard Disk
37
2
C Press [Administrator Tools].
D Press [Auto Erase Memory Setting].
If the setting to be specified does not appear, press [TNext] to scroll down to
other settings.
E Press [On], and then select the method of erasing the data.
Select the method of erasing the data from [NSA], [DoD], or [Random Numbers].
When you select “Random Numbers”
A Press [Change].
B Enter the number of times that you want to overwrite using the number
keys, and then press [#].
F Press [OK].
Auto Erase Memory is set.
Important
❒
When Auto Erase Memory is set to "On", temporary data that remained on
the hard disk when Auto Erase Memory was "Off" might not be overwritten.
Note
❒ Should the main power switch of the machine be turned off before over-
writing is completed, the temporary data will remain on the hard disk un-
til the main power switch is next turned on and overwriting is resumed.
❒ If the overwriting method is changed while overwriting is in progress, the
remainder of the temporary data will be overwritten using the method set
originally.
Canceling Auto Erase Memory
A Follow steps
A
to
D
in “Auto Erase Memory Setting”.
B Press [Off].
C Press [OK].
Auto Erase Memory is disabled.
Note
❒ To set Auto Erase Memory to "On" again, repeat the procedure in “Auto Erase
Memory Setting”.
To Next Page
Loading...
