Enabling Authentication
75
5
E Select [Windows Authentication].
Note
❒ If you do not want to use user authentication management, select [Off].
F Press [Change] for “Domain Name”, enter the name of the domain controller
to be authenticated, and then press [OK].
G Select the "Printer Job Auth." level.
Note
❒ If you select [Entire], you cannot print using a printer driver or a device that
does not support authentication. To print under an environment that does
not support authentication, select [Simple (All)]. By making this setting, only
registered users will be able to print.
❒ If you select [Simple(Limitation)], you can specify clients for which printer job
authentication is not required. Specify [Parallel Interface: Simple], [USB: Sim-
ple] and the clients’ IP address range in which printer job authentication is
not required. Specify this setting if you want to print using unauthenticat-
ed printer drivers or without any printer driver. Authentication is required
for printing with non-specified devices.
❒ If you select [Simple (All)], you can print even with unauthenticated printer
drivers or devices.Specify this setting if you want to print with a printer
driver or device that cannot be identified by the machine or if you do not
require authentication for printing.However, note that, because the ma-
chine does not require authentication in this case, it may be used by unau-
thorized users.
Reference
For details, see p.86 “Printer Job Authentication Levels and Printer Job
Types”.
To Next Page
Loading...
