Management Based on Authentication and Access Control
80
5
Specifying LDAP Authentication
A Press the {User Tools/Counter} key.
B Press [System Settings].
C Press [Administrator Tools].
D Press [User Authentication Management].
E Select [LDAP Authentication].
Note
❒ If you do not want to use user authentication management, select [Off].
F Select the LDAP server to be used for LDAP authentication.
G Select the "Printer Job Auth." level.
Note
❒ If you select [Entire], you cannot print using a printer driver or a device that
does not support authentication. To also print under an environment that
does not support authentication, select [Simple (All)]. By making this setting,
only registered users will be able to print.
❒ By selecting [Simple(Limitation)], you can specify clients for which printer
job authentication is not required. Specify [Parallel Interface: Simple], [USB:
Simple] and the clients’ IP address range in which printer job authentication
is not required. Specify this setting if you want to print using unauthenti-
cated printer drivers or without any printer driver. Authentication is re-
quired for printing with non-specified devices.
To Next Page
Loading...
