4. Select [Network Security Level] using [ ] or [ ], and then press the [OK] key.
5. Select the network security level using [ ] or [ ], and then press the [OK] key.
Select [Level 0], [Level 1], or [Level 2].
6. Press the [User Tools/Counter] key.
• p.30 "Logging on Using Administrator Authentication"
• p.31 "Logging off Using Administrator Authentication"
Making Settings Using Web Image Monitor
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
The network administrator can log on.
Enter the login user name and login password.
4. Click [Configuration], and then click [Network Security] under "Security".
5. Select the network security level in "Security Level".
6. Click [OK].
7. Click [OK].
8. Click [Logout].
6. Enhanced Network Security
136
To Next Page
Loading...
