3. Select [Interface Settings] using [ ] or [ ], and then press the [OK] key.
4. Select [Network] using [ ] or [ ], and then press the [OK] key.
5. Select [Permit SNMPv3 Communictn.] using [ ] or [ ], and then press the [OK] key.
6. Select [Encryption Only] using [ ] or [ ], and then press the [OK] key.
7. Press the [User Tools/Counter] key.
• To use SmartDeviceMonitor for Admin for encrypting the data for specifying settings, you need to
specify the network administrator's [Encryption Password] setting and [Encryption Key] in [SNMP
Authentication Information] in SmartDeviceMonitor for Admin, in addition to specifying [Permit
SNMPv3 Communication] on the machine. For details about specifying [Encryption Key] in
SmartDeviceMonitor for Admin, see SmartDeviceMonitor for Admin Help.
• If network administrator's [Encryption Password] setting is not specified, the data for transmission may
not be encrypted or sent. For details about specifying the network administrator's [Encryption
Password] setting, see "Registering the Administrator".
• p.30 "Logging on Using Administrator Authentication"
• p.31 "Logging off Using Administrator Authentication"
6. Enhanced Network Security
150
To Next Page
Loading...
