When the Finisher SR3030 is installed: (Type 3 and 4)
When the Booklet Finisher SR3020 is installed: (Type 3 and 4)
3. Press [OK].
4. Place the originals, and then press the [Start] key.
• When placing an original on the exposure glass, start with the first page to be copied. When placing
originals in the ADF, set so that the first page is on the top.
• You can change the punch hole positions shown on the initial display under Input/Output in User
Tools. For details, see “Input/Output”.
• You cannot punch on thick paper heavier than 163 g/m
2
(43 lb.).
2. Basic Copying
92
To Next Page
Loading...
