EasyManuals Logo

Ricoh CL4000DN Maintenance Guide

Ricoh CL4000DN
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
Troubleshooting
86
Hardware Problem
Parallel I/F
There is a problem with the
parallel interface.
If you use the parallel I/F, re-
place the interface cable that
caused the error. Turn the
power off, and then on. Re-
move and re-install the IEEE
1284 interface board correct-
ly. If the message appears
again, contact your sales or
service representative.
Hardware Problem
Printer font
Problems with the font file for
the Printer module.
It is necessary to replace the
print module.
Hardware Problem
USB
There is a problem related to
the Universal Serial Bus Con-
nection and Hardware.
Turn the power off, and then
on. If the message appears
again, contact your sales or
service representative.
Hardware Problem
Wireless Board
An error was detected in the
IEEE 802.11b interface unit or
the Bluetooth interface unit.
Turn the power off, and then
on. Remove and re-install the
IEEE 802.11b interface unit or
the Bluetooth interface unit
correctly.
If the message appears
again, contact your sales or
service representative.
See “Attaching IEEE 802.11b
Interface Unit Type H” or “At-
taching Bluetooth Interface
Unit Type 3245”, Setup
Guide.
Hardware Problem
Wireless Card
The IEEE 802.11b interface
unit or the Bluetooth interface
unit could not be detected
when the power was turned
on. The IEEE 802.11b inter-
face card or the Bluetooth in-
terface card was removed
after the power was turned on.
An error was detected in the
IEEE 802.11b interface card or
the Bluetooth interface card.
Turn the power off, and then
on. Remove and re-install the
IEEE 802.11b interface unit or
the Bluetooth interface unit
correctly.
If the message appears
again, contact your sales or
service representative.
See “Attaching IEEE 802.11b
Interface Unit Type H” or “At-
taching Bluetooth Interface
Unit Type 3245”, Setup
Guide.
Hex Dump Mode In Hex Dump Mode. No action required.
I/O Buffer Overflow The maximum size of the I/O
buffer has been exceeded.
Increase the size of the I/O
buffer through the I/F Setup.
Messages Description Recommended Action

Table of Contents

Other manuals for Ricoh CL4000DN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ricoh CL4000DN and is the answer not in the manual?

Ricoh CL4000DN Specifications

General IconGeneral
BrandRicoh
ModelCL4000DN
CategoryPrinter
LanguageEnglish

Related product manuals