Maintaining Your Machine
55
5
Maintaining Your Machine
If the exposure glass, exposure glass
cover, ADF belt is dirty, copy clarity
may be reduced. Clean these parts if
they are dirty.
❖
❖❖
❖ Cleaning the machine
Wipe the machine with a soft,
damp cloth. Then wipe it with a
dry cloth to remove the water.
Important
❒ Do not use chemical cleaner or or-
ganic solvents such as thinner or
benzene. If such substances get in-
side the machine or melt plastic
parts, a failure might occur.
❒ Do not clean parts other than those
explicitly specified in this manual.
Other parts should only be cleaned
by your service representative.
Cleaning the Exposure Glass
Cleaning the Exposure Glass
Cover
Cleaning the ADF
ND1C0200
TRSR140E
KirC2_AEcopyF1_FM.book Page 55 Wednesday, April 27, 2005 7:26 PM
To Next Page
Loading...
