Ricoh G600 - Connecting the Camera to a Printer

114
Direct Printing
4
Connect your camera to a printer using the USB cable provided.
1 Make sure that the camera is off.
2 Turn the terminal cover
knob of the camera in the
direction of the arrow to
open the cover.
3 Connect your camera to a
printer using the USB cable
provided.
• Turn on the printer if it is not already on.
• Your camera turns on automatically.
Caution------------------------------------------------------------------------------------------
• Before opening or closing the battery/card cover or terminal cover, be sure to remove
any water, sand or mud adhering to the camera, and avoid opening and closing the
cover in places where such contaminants may get inside the camera.
• Do not force the USB cable into the terminal.
• Do not apply excessive force with the USB cable connected.
• When using the USB cable, do not move the camera with the USB cable.
Note ----------------------------------------------------------------------------------------------
To disconnect the camera from the printer, check that the power is off on both units
before disconnecting the USB cable between them.
Connecting the Camera to a Printer