134
Changing Camera Settings
5
Immediately after you press the shutter release button, the still
image taken is displayed on the screen for a moment so you can
check it. By default, the image confirmation time is set to 0.5
seconds, but this can be changed.
To change the image confirmation time, follow the steps below.
1
Display the SETUP menu.
• For the operating procedure, see P.123.
2
Press the " button to select [LCD CONFIRM.] and
press the $ button.
3
Press the !" buttons to select
the desired setting.
4
Press the MENU/OK button.
Changing Image Confirmation Time
(LCD CONFIRM.)
Available Settings
OFF (Image not displayed for confirmation)
0.5SEC. *Default setting
1 SEC.
2 SEC.
3 SEC.
To Next Page
Loading...
