Ricoh Gestetner 5430 - Dirt on the Front Side of Paper (Black Line;Stain); White Prints or Incomplete Prints

Troubleshooting
94
5
Dirt on the Front Side of Paper (Black Line/Stain)
Note
❒ If there is no margin or if there is a solid image area near the leading edge of
the original, make a margin of at least 5mm, 0.2" at the leading edge. Other-
wise, the paper exit pawl might become dirty and cause black lines on prints.
❒ Check the exposure glass cover and clean it if dirty. See p.103 “Exposure
Glass Cover”.
❒ Check the exposure glass and clean it if dirty. See p.103 “Exposure Glass”.
❒ When black lines or stains still appear on prints even if you clean the above,
contact your service representative.
White Prints or Incomplete Prints
• Make sure that the paper feed side plates touch the paper lightly. Shift the
lock lever backward.
• When you use the optional document feeder, make sure that the original
guides contact the originals lightly.
GRBLAC1E
GRWHIT0E
TSLY015E
PinkGold-F_V4_FM.book Page 94 Tuesday, May 27, 2003 3:33 PM