Ricoh Gestetner 5430 - Printing on Thick or Thin Paper; Pressure Lever Position

Operation
30
1
Printing on Thick or Thin Paper
When you make prints on thick (127.9
to 209.3g/m
2
, 34.0 to 55.6 lb), stan-
dard (52.3 to 127.9g/m
2
, 13.9 to 34.0
lb) or thin (47.1 to 52.3g/m
2
, 12.5 to
13.9 lb) paper, perform the following
steps.
Pressure Lever Position
A
AA
A
Shift the feed roller pressure le-
ver to the Thick, Standard, or
Thin paper position.
Note
❒ Shift the lever according to the
paper weights as shown in the
following table.
*1
When paper is smaller than B5,
5
1
/
2
" × 8
1
/
2
" and heavier than
81.4g/m
2
(21.6 lb), move the
feed roller pressure lever to the
Thin paper position.
B
BB
B
Make sure that paper feed side
plates touch the paper lightly.
C
CC
C
When you finish prints, shift the
feed roller pressure lever to the
Standard paper position.
Metric
Version
Inch
Version
Thick 127.9 —
209.3g/m
2
34.0 —
55.6 lb
Standard 52.3 —
127.9g/m
2
13.9 —
34.0 lb
Thin
*1
47.1 —
52.3g/m
2
12.5 —
13.9 lb
ZCTH150E
PinkGold-F_V4_FM.book Page 30 Tuesday, May 27, 2003 3:33 PM