Maintenance or repair is required. Prepare for maintenance or consider
repairing the machine.
Paper is jammed. See the animated illustration displayed on
the control panel, and remove the jammed
paper.
When Paper or an Original Is Jammed
An original has jammed. See the animated illustration displayed on
the control panel, and remove the jammed
original.
When Paper or an Original Is Jammed
Paper has run out. Load paper into the paper tray.
Loading Paper into the Paper Tray
Toner is almost depleted, or has run out. Prepare a replacement toner. Replace the
toner when it runs out.
Replacing the Toner
If appears when there is a lot of
toner, pull out the print cartridge by
following the toner replacement
procedure that is displayed on the
screen, and then set it back again.
The waste toner bottle is full, or almost
full.
Prepare a replacement waste toner bottle.
Replace the bottle when it becomes full.
Replacing the Waste Toner Bottle
Staples are nearly depleted, or have run
out.
Prepare a cartridge for replacement, and
load it when the staples run out.
Replenishing the Staples
The hole punch receptacle is full. Empty the receptacle.
When the Hole Punch Receptacle Is Full
A cover is open. Check that all covers of the machine and
options are closed.
For the names and the contact information of consumables, check [Settings] [Inquiry]. Press
[Home]
( ) after completing the operation to close
[Settings]
.
To Next Page
Loading...
